1.Introduction
Industrial circulation cooler is designed by the international advanced cooling system, which can be used in any small cooling system radiating through water-cooling. When it supports the laser machine, please see as following:
1/ works with all round safekeeping function of cut -off and over temperature warning.
2/ Closed stainless steel water tanks, it can work for a long rime with one watering.
3/ real-time monitoring the temperature to know exactly the work condition of heating elements
4/ Professional radiator with great volume of heat diapation that forces the wind cool.
5/ Automatic work, not needing manual work. (Coordinating with the system)
6/ outputting warning signals keep the sense organs safe quickly so it can protect the laser cutting machine in case any thing happen
2.Specification
1/ Power supply: 220VAC/50Hz
2/ Power consumption: 140VA max
3/ Cooling water tank capacity: 9L
4/ Cooling water tank material: stainless steel
5/ Cooling: radiator that forces the wind cool
6/ Amount of cooling: 50W/ºC
7/ Way of circulation: forces circulation
8/ Maximum water current capacity: 15L/MIN
9/ Maximum water pumping lift: 6m
10/ Diameter of input and output hole: 10mm
11/ External dimensions: 470*262*373mm
12/ Weight: approx.16kg
3/. Notes
1)Don’t power on if no water, or it may break the cooler including laser engraving machine.
2)Put it in ventilated and dry environment, far from other heaters. And its vent is away from the obstacles above 150mm.
3)Draining is necessary when it is out of work or transported for a long time
4)When the water temperature is under 10ºC, its fans will stop work, and when over 20ºC, it will continue to work.
5)Better is to use soft water (distilled water or pure water)
4/ Installations for the First Time
Its installation is very easy and you can do it according to the following steps.
1)Open the packing and examine the machine and accessories
2)Connect the outlet and inlet pipes
3)Twist off the machine crown note drainage opening, join the water
4)Plug in and turn on the power
5)Check the water level of the water tank (the water level should be 80-150mm away from the tender filling hole). Screw down the tender filling hole nut tightly.
The installation is over now, and it only needs to turn on the power next time (if the cooler is automatic, it can be on and off by its own and does not need intervention).
5/ Maintenance
Please change the cooling water after a long time use (the time depends on the water condition). Then it can help to keep the laser engraver working well.